5. Setup5.3 Setting the RCU addressWhat has to be done ?To allow the communication between the RCU and the projector the RCU has to be programmed with the same address as theprojector.This address must be in the range 0–9.To know the address of the projector, one can visualize it in projection mode (on screen) as well as in standby mode (shown withthe LED’s on top cover of the projector).For more info on addresses see the appendixAt this stage the image projected may happen to be upside down or mirrored, this can be set in the Installationmenu under Projector orientation (see further setting up the projector’s orientation).Displaying the Projector Address in Standby mode1. Press the Address key (recessed key on the RCU) with a pencil.9 0E N T E RM E N U B A C KD I G IZ O O MP H A SEP A U SE PI PL O G OImage 5-4All the LED’s (3) on the top cover of the projector go out.Then LED1 starts blinking green the number of hundreds. After that LED2 starts blinking the number of tens. Finally LED3 startsblinking green the number of units. If this is done, the original status of the LED’s is restored.Displaying the Projector Address in projection mode1. Press the Address key (recessed key on the RCU) with a pencil.The projector’s address will be displayed on the screen in a text boxProgramming the RCU1. Push the address key If the address is not entered within 5 seconds, the RCU returns to its default address (zero address) andcontrols then all projectors in the room.2. Enter the same address with the digit buttons within 5 seconds after pushing the address key.The projector can now be controlled with the RCU.For example : if the projector address is 3, then press "3" on the RCU to set the RCU’s address to match theprojector’s address.Common address/Projector address : Beside the projector address, the projector disposes also of a Commonaddress which can be set to “0” or “1” (by default “0”).In other words, an RCU set to address “0” will always control a projector regardless of its projector address(since it uses the common address).52 R59770330 SIM 7QP SERIES 07/10/2013
