5. Driver and software featuresImage 5-3Supported display controllersConference CloneView is supported by all systems with an MXRT-x400 or later display controller.5.3.2 OperationUsing Conference CloneViewCreate a new clone session and select up to 3 source displays and up to 3 target displays for the clonesession. The source and target displays must be attached to the same display controller. The clonedimage can be scaled to fit the resolution of the target display. With a Barco Display Controller with 4outputs, it is possible to have two independent cloning sessions.When the cursor is over to the cloned image, it will change to the Barco cursor. The user can zoom in onthe cloned image by rolling the mouse wheel and pan the image with the left mouse button.When zoomed in, the cloned image may be bigger than the clone display and part of theimage may be off screen. Click and drag the left mouse button and move the cursor topan to the portion of the image that is off screen.Right clicking on the cloned image will bring up the Conference CloneView context menu. The menuoptions are described below.Image 5-4Conference CloneView Context Menu• Minimize: This minimizes the cloned image to show the desktop.• Zoom to 1:1: Changes the scaling to 1 target pixel per source pixel. If the source resolution is largerthan the target resolution, panning will be necessary to see the entire image. If the source resolutionis smaller than the target resolution, black boarders will show around the image. “Stretch to fill” haspriority over this option.• Reset Zoom Level: When “Stretch to fill” is selected in the Barco System Settings Control Panel, thiswill reset to the minimal zoom possible to make the stretched aspect ratio possible. When “Stretch tofill” is not selected, this option will reset the zoom to 1:1. When the image is already at the minimumzoom level, this option is grayed out.• Pause Cloning: This suspends updates to the clone image; the source can continue to change whilethe target image remains static. Select it a second time to resume active cloning.• Stop Cloning: Select this option to stop cloning on the current Display Controller. It has the sameeffect as clicking on the Stop Cloning button in the Barco System Settings Control Panel.24 K5905271 DISPLAY CONTROLLER 27/02/2017