7. AdvancedImage 7-358. Press ENTERA dialog box is displayed9. Adjust the red white level (gain) on a minimal valueImage 7-3610.Adjust the blue white level (gain) to a minimal valueNote: this minimal value is not necessary , provided that the 2 other colors are not influencing too much the color to be adjusted,in fact the aim is to minimize the effect of the two other colors since there is a risk of reaching too soon the transition(bright spots) due to the contribution of these two other colors signals.11. Adjust the Green white level (gain) until bright spots appear on the white part of the image12.Adjust the Blue white level (gain) until bright spots appear on the white part of the image13.Adjust the Red white level (gain) until bright spots appear on the white part of the imageThe projected image should now be noisy neutral grey.If one uses a checkerboard pattern, the bright spots should appear in the white blocks.The input balance settings are stored in the image file, each source has its own input balance.7.4.6 Input stereo syncWhat can be done?This menu allows different settings on the incoming stereo sync signal to allow the perfect match with the Image Generator or PC.With Swapped Fields we can swap the left and right fields of the stereo image at the input stage i.e. the left field will be processedin the projector as left field or as right field and the right field processed as left field or right field.R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013 75
