4. InstallationThe desktop can be enabled/disabled, "Desktop", page 129Using the desktop input makes only sense when using the Barco Desktop integration software. The Desktopintegration software is covered in the Desktop integration User Guide.4.5.9 DVI outputDVI outputDESKTOP INPUTDESKTOP INPUTR / PRR / PR G / YG / Y B / PBB / PB Hs / CsHs / Cs VsVs VIDEOVIDEO S-VIDEOS-VIDEODVIDVIIN1IN1 IN2IN2L1L1STEREO INPUTSTEREO INPUT STEREO OUTPUTSTEREO OUTPUTL2L2 L3L3IN1IN1 IN2IN2 IN1IN1 IN2IN2COMPUTERCOMPUTERRS 232 CRS 232 C DVIDVI R.C.R.C.Image 4-23DVI outputThe DVI output is a single link DVI output signal, having the following specifications:• resolution: is the same as the native resolution of the projector;• vertical refresh rate: 60 Hz;• signal type: digital signal (DVI).It reflects the projected image, excluding Geometry corrections, Soft edge and Black level correction, Dynacolor settings and OSD.C AUTION : If the projector runs in synchronous mode, the DVI output is synchronous with the input signal.In this mode, most monitors will not display the signal in a correct way!C AUTION : If the selected input signal is a stereo signal, a black image is displayed at the DVI output.4.5.10 Stereo connectionsWhat can be done ?The stereo sources sync signals have to be connected to the 4th layer of the front panel. The stereo input layer holds 6 mini DINconnectors and 2 BNC connectors.The 6 mini DIN connectors are the stereo sync input connections for respectively from the left to the right, the 1 st ,2 nd and 3 rd layer.The order is from left to right eg. for the DVI input board, the left DIN connector (L3/IN1) is for the left connector on the DVI inputboard and the right DIN connector (L3/IN2) is for the right connector on the DVI input board.R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013 29
