184 Copyright © Acronis, Inc., 2000-200910. Specify the output folder and the full path to the resulting ISO file including the file name or themedia to create.11. Build the Bart PE.12. Burn the ISO to CD or DVD (if this has not been done yet) or copy to a flash drive.Once the machine boots into the Bart PE and you configure the network connection, select Go ->System -> Storage -> Acronis Backup & Recovery 10 to start.6.10.2. Connecting to a machine booted from mediaOnce a machine boots from bootable media, the machine terminal displays a startup window withthe IP address(es) obtained from DHCP or set according to the pre-configured values.Remote connectionTo connect to the machine remotely, select Connect -> Manage a remote machine in the consolemenu and specify one of the machine's IP addresses. Provide the user name and password ifthese have been configured when creating the bootable media.Local connectionAcronis Backup & Recovery 10 Management Console is always present on the bootable media.Anyone who has physical access to the machine terminal can run the console and connect. Justclick Run management console in the bootable agent startup window.6.10.3. Working under bootable mediaOperations on a machine booted with bootable media are very similar to backup and recovery underthe operating system. The difference is as follows:1. Disk letters seen under Windows-style bootable media might differ from the way Windowsidentifies drives. For example, the D: drive under the rescue utility might correspond to the E:drive in Windows.Be careful! To be on the safe side, it is advisable to assign unique names to the volumes.2. The Linux-style bootable media shows local disks and volumes as unmounted (sda1, sda2...).3. The Linux-style bootable media cannot write a backup to an NTFS-formatted volume. Switch tothe Windows style if you need to do so.4. You can switch the bootable media between the Windows style and the Linux style by selectingTools > Change volume representation.5. There is no Navigation tree in the media GUI. Use the Navigation menu item to navigate betweenviews.6. Tasks cannot be scheduled; in fact, tasks are not created at all. If you need to repeat theoperation, configure it from scratch.7. The log lifetime is limited to the current session. You can save the entire log or the filtered logentries to a file.8. Centralized vaults are not displayed in the folder tree of the Archive window.To access a managed vault, type the following string in the Path field:bsp://node_address/vault_name/
