A-Tach Mounts STL-1 Quick Start Manual

A-Tach # 50377Designed for: Audi Q5 2009 - 2017STL-1 A-TachMountsNOTICE: A-Tach Mounts will not be responsible forany damage to the vehicle due to the installationand/or use of the product. The product has beentested to fit securely to the listed vehicles.Instructions are provided for your convenience.You are responsible for the use of the product andto determine if you have the skill to attach theproduct without causing damage to your vehicle orthe product.Read all instructions and view the photos beforeattaching this product.For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFOREattaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often themount will appear to be a little too big or small for the intended location. The vehicle mount must beinstalled BEFORE a device holder is screwed onto the vehicle mount.Once screwed together the products are considered used and non-refundable.The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.Once it is attached, it should remain attached until you would like to permanently remove it.WARNING: AVOID extreme heat conditions. It can damage the device and the mount.(1) Clean the area where the mount will attach. Themount will attach into the seam between the ventopeners and the silver vent trim illustrated with thearrow in the photo.(2) Remove the covering from the tape. Press thethin top edge of the mount into the top seam. Usethe seam tool if needed to open the seam a little.(3) Press upward on the mount to flex the thinlower edge of the mount into the lower seam. Usethe seam tool if needed to open the seam a little.(4) Press the upper and lower edges of the mountall the way into the seams. The tape will not leaveany residue if the mount is removed in the future.

/ 2

Related manuals for A-Tach Mounts 50377