A-Tach Mounts ST-1 Manual

Also see for ST-1: Instructions Manual Quick start guide Instructions Instructions

A-Tach # 50276Designed for: Hyundai Elantra 2021 - 20__ST-1 A-TachMountsNOTICE: A-Tach Mounts will not be responsible forany damage to the vehicle due to the installationand/or use of the product. The product has beentested to fit securely to the listed vehicles.Instructions are provided for your convenience.You are responsible for the use of the product andto determine if you have the skill to attach theproduct without causing damage to your vehicle orthe product.Read all instructions and view the photos beforeattaching this product.For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFOREattaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often themount will appear to be a little too big or small for the intended location. The vehicle mount must beinstalled BEFORE a device holder is screwed onto the vehicle mount.Once screwed together the products are considered used and non-refundable.The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.Once it is attached, it should remain attached until you would like to permanently remove it.WARNING: AVOID extreme heat conditions. It can damage the device and the mount.WARNING: DO NOT interact with the device while the vehicle is in motion.(1) Clean the area where the mount will attach. Thelower edge of the mount will attach into the seamillustrated with the arrow in the photo.(2) The top edge of the mount will latch onto thetop of the frame around the vents. Between thebottom of the display frame and the top of thevent frame and illustrated with the arrow above.(3) Press the thin edge of the seam tool into thelower seam illustrated in photo one.(4) Remove the covering from the tape. Insert thethin lower edge of the mount into the seam.See additional instructions on the back side.

/ 2

Related manuals for A-Tach Mounts ST-1