A-Tach Mounts 50321 Quick Start Manual

A-Tach # 50321Designed for: Acura TLX 2021 - 20__ST-1 A-TachMountsNOTICE: A-Tach Mounts will not be responsible forany damage to the vehicle or product due to theinstallation and/or use of the product. The product hasbeen tested to fit securely to the listed vehicles.Instructions are provided for your convenience.You are responsible to determine if you have theskill to attach the product without causing damageto your vehicle or the product.Read all instructions and view the photos beforeattaching this product.For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFOREattaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often themount will appear to be a little too big or small for the intended location. The vehicle mount must beinstalled BEFORE a device holder is screwed onto the vehicle mount.Once screwed together the products are considered used and non-refundable.The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.Once it is attached, it should remain attached until you would like to permanently remove it.WARNING: AVOID extreme heat conditions. It can damage the device and the mount.(1) Clean the area where the mount will attach. Theforward / lower edge of the mount will attach intothe seam between the two panels on the side of thecenter console illustrated with the arrow in thephoto. The tab on the mount will go into an unseenopening in the seam that is about 1.5 inches upfrom the bottom of the seam.(2) The upper right edge of the mount will attachinto the seam between the console side panels andthe hard plastic panel on the left center consoleillustrated with the arrow in the photo.See additional instructions on the back side.

/ 2

Questions and answers

Heed help?

Ask question about this manual

Related manuals for A-Tach Mounts 50321