A-Tach Mounts ST-1 Quick Start Manual

A-Tach # 50080Designed for: Ford Expedition 2007-2017ST-1 A-TachMobile Device MountsNOTICE: A-Tach Mounts will not be responsible forany damage to the vehicle due to the installationand/or use of the product. The product has beentested to fit securely to the listed vehicles.Instructions are provided for your convenience.You are responsible for the use of the product andto determine if you have the skill to attach theproduct without causing damage to your vehicle orthe product.Read all instructions and view the photos beforeattaching this product.For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFOREattaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often themount will appear to be a little too big or small for the intended location. The vehicle mount must beinstalled BEFORE a device holder is screwed onto the vehicle mount.Once screwed together the products are considered used and non-refundable.The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.Once it is attached, it should remain attached until you would like to permanently remove it.WARNING: AVOID extreme heat conditions. It can damage the device and the mount.(1) See additional notes on back. Clean the areawhere the mount will attach. Remove the coveringfrom the tape. The tape will not leave any residue ifthe mount is removed in the future. Insert theseam tool into the seam between the frame aroundthe radio and the padded dash top. See photo.(2) Insert the lower edge of the mount into theseam next to the seam tool. Press the mount allthe way into the seam until the back side of themount touches the padded dash top.(3) Pull out the seam tool and insert it into theseam at the very front of the dash top tray.Between the tray and the padded dash top. Not theseam of the speaker grill.(4) Press the mount forward and hook the frontedge of the mount into the seam next to the seamtool. Press down on the mount to make sure thetape makes connection to the dash panel.See additional instructions on the back side.

/ 2

Related manuals for A-Tach Mounts 50080