A-Tach Mounts 50322 Quick Start Manual

A-Tach # 50322Designed for: Volkswagen Taos 2022 - 20__ST-1 A-TachMountsNOTICE: A-Tach Mounts will not be responsible forany damage to the vehicle or product due to theinstallation and/or use of the product. The product hasbeen tested to fit securely to the listed vehicles.Instructions are provided for your convenience.You are responsible to determine if you have theskill to attach the product without causing damageto your vehicle or the product.Read all instructions and view the photos beforeattaching this product.For best results, hold the vehicle mount over the place where the mount attaches to the dash BEFOREattaching the device holder to the vehicle mount to ensure a proper fit with the location. Most often themount will appear to be a little too big or small for the intended location. The vehicle mount must beinstalled BEFORE a device holder is screwed onto the vehicle mount.Once screwed together the products are considered used and non-refundable.The vehicle mount is not designed to be attached and taken off the vehicle repeatedly or on a regular basis.Once it is attached, it should remain attached until you would like to permanently remove it.WARNING: AVOID extreme heat conditions. It can damage the device and the mount.(1) Clean the area where the mount will attach. Theupper edge of the mount will attach into the seambetween the frame around the display and the dashpanel covering the display illustrated with thearrows in the photo.(2) The lower edge of the mount will attach intothe seam between the frame around the vents andthe separating dash panel above the ventsillustrated with the arrows in the photo.(3) Use the seam tool if needed to open the lowerseam a little.(4) Remove the covering from the tape. Thenpress the thin lower edge of the mount into thelower seam. The lower side of the mount is longer.See additional instructions on the back side.

/ 2

Related manuals for A-Tach Mounts 50322