1-2Parametervlan-id: ID of the specific VLAN interface.DescriptionUse the display interface Vlan-interface command to display the information about the VLANinterface.VLAN interface is a virtual interface in Layer 3 mode, used to realize the layer 3 communicationbetween different VLANs. Each VLAN has a VLAN interface, which can forward packets of the localVLAN to the destination IP addresses at the network layer.If the vlan-id argument is specified, the information about the specified VLAN interface is displayed; ifthe vlan-id argument is not specified, the information about all the created VLAN interfaces is displayed.Related command: interface Vlan-interface.Example# Display the information about VLAN-interface2. display interface Vlan-interface 2Vlan-interface2 current state : DOWNLine protocol current state : DOWNIP Sending Frames' Format is PKTFMT_ETHNT_2, Hardware address is 000f-e207-4101Internet Address is 10.1.1.1/24 PrimaryDescription : Vlan-interface2 InterfaceThe Maximum Transmit Unit is 1500Table 1-1 Description on the fields of the display interface Vlan-interface commandField DescriptionVlan-interface2 current state Current state of the VLAN interfaceLine protocol current state Current state of the link protocolIP Sending Frames' Format Format of the frames that IP sendsHardware address MAC address corresponding to the VLAN interfaceInternet Address IP address corresponding to the VLAN interfaceDescription Description string of the VLAN interfaceThe Maximum Transmit Unit Maximum transmission unit (MTU)display vlanSyntaxdisplay vlan [ vlan-id [ to vlan-id ] | all | dynamic | static ]ViewAny viewParametervlan-id: VLAN ID, in the range of 1 to 4094.
