Dial-UpParameterseconds: Interval for originating the next call, ranges from 0 to 65535 seconds. Bydefault, the interval is 20 seconds.DescriptionUsing the dialer timer enable command, you can configure an interval for the nextcall attempt on an interface after the link is disconnected. Using the undo dialertimer enable command, you can restore the default interval.Example# Set the interval for DCC to make the next call attempt to 5 seconds.[3Com-Serial0] dialer timer enable 51.1.17 dialer timer idleSyntaxdialer timer idle secondsundo dialer timer idleViewPhysical or dialer interface viewParameterseconds: Time that a link is allowed to be idle, ranges from 0 to 65535 seconds. Bydefault, seconds is 120 seconds.DescriptionUsing the dialer timer idle command, you can configure the interval that a link isallowed to be idle (in other words, the interval when there is no packets which complywith the “permit” statements transmitted) after a call has been set up on the interface.Using the undo dialer timer idle command, you can restore the default duration.After a link is set up, the timer idle timer will take effect. If no interesting packets aretransmitted on the link within the specified time, DCC will automatically disconnect thelink. If timer idle is set to 0, the link will never be disconnected, regardless of whetherthere are no packets which comply with the “permit” statements being transmittedover the link or not.17
