3Com Router Command Reference Guide — V1.00DescriptionUsing the ipx network command, you can configure the IPX network ID. Using theundo ipx network command, you can cancel the IPX network ID.By default, IPX routing is disabled.IPX router function can be started only after the IPX network ID is configured on theinterface.To activate the IPX module on an interface, it is necessary to use the ipx networkcommand. If it is necessary to change the encapsulation type of the IPX frame, youcan use the ipx encapsulation command.For related commands, see ipx encapsulation, ipx enable.Example# Activate the IPX route at Ethernet0.[Quidway] ipx enable[Quidway-Ethernet0] interface ethernet 0[Quidway-Ethernet0] ipx network 25.1.11 ipx rip load-balance-pathSyntaxipx rip load-balance-path numberundo ipx rip load-balance-pathViewSystem viewParameternumber: The maximum of IPX parallel routes, the range is 1~64. By default, it is 1.DescriptionUsing the ipx rip load-balance-path command, you can configure the maximumnumber of IPX parallel route. Using the undo ipx rip load-balance-path command,you can restore the maximum number of IPX parallel route to default.If there is more than one route for the same destination, the system can realize loadbalance to send data via the routes in turn.82
