3Com Command Reference Guide — V1.00Parameterah-new: Using the AH protocol specified in RFC2402.ah-esp-new: Using the ESP and then AH on packets.esp-new: Using the ESP protocol specified in RFC2406.DescriptionUsing the transform command, you can configure a security protocol used by aproposal set. Using the undo transform command, you can restore the defaultvalue.By default, the setting is esp-new, that is, the ESP protocol specified in RFC2406.This command is applicable to the IPSec module of the operating system and cryptocard.The proposal sets used by the IPSec policy set at both ends of the security tunnelmust be set as having the same security protocol.For related commands, see ipsec proposal, ipsec policy (system view), ipsecpolicy (interface view), security acl, tunnel local, tunnel remote, sainbound/outbound.Example# Configure a proposal set using AH.[3Com]ipsec proposal trans1[3Com-ipsec-proposal-trans1]transform ah-new4.1.42 tunnel localSyntaxtunnel local ip-addressundo tunnel localViewIPSec policy viewParameterip-address: Local address.86
