Interface ManagementViewAll viewsParameterNoneDescriptionUsing the display interfaces brief command, you can view information on thephysical status and protocol status of all interfaces.This command is the simplified form of the display interfaces command. It can beused to display the brief information on the physical status and protocol status of allinterfaces.For related commands, see display interfaces.Example# Display the information on the physical status and protocol status of all theinterfaces.[3Com]display interfaces briefAux0 is up, line protocol is up (spoofing)Link-protocol PPPBridge-Template1 is up, line protocol is upDialer1 is up (spoofing), line protocol is up (spoofing)Link-protocol PPPEthernet0 is up, line protocol is up (loop)Internet address is 1.1.1.1 255.255.255.0 1.1.1.255Internet address is 1.1.2.2 255.255.255.0 1.1.2.255 subEthernet1 is down, line protocol is downHardware address is 00-e0-fc-99-00-33Auto-Negotiation is enabled, Half-duplex, 10Mb/sSerial0 is standby, line protocol is downLink-protocol X.25Serial1 is standby, line protocol is downLink-protocol PPP1.1.4 flow-intervalSyntaxflow-interval minutes7
