Interface Management1.1.2 display interfacesSyntaxdisplay interfaces type number [ . sub-number ]ViewAll viewsParametertype: The type of the interface to be configured. Together with interface-number, itspecifies an interface.number: The number of the interface. Together with interface-type, it specifies aninterface.sub-number: Sub interface number.DescriptionUsing the display interfaces command, you can view the statistics of an interface.If this command is used, the following information will be displayed:z The physical status and protocol status of the interfacez Physical features of the interface (sync/async, DTE/DCE, clock selection,external cable, etc.)z IP address of the interfacez The run status, statistics, etc. of the link-layer protocols encapsulated at theinterfacez Statistics of input and output packets at the interfaceFor related commands, see display interfaces brief, reset counters interface.Example# Display the statistics of Serial 0 (with PPP link layer protocol).[3Com]display interfaces serial 0Serial0 is up, line protocol is upphysical layer is synchronous, baudrate is 64000 bpsinterface is DCE, clock is DCECLK, cable type is RS232Maximum Transmission Unit is 1500Internet address is 1.1.1.1 255.255.255.0Link-protocol is PPPLCP opened, IPCP initial, IPXCP initial, CCP initial, BRIDGECP initial5
