2N - VoiceBlue Lite• List of Terminal AT Commands• Records on Operation (LOG)• Records on Calls (example)• Statistics – Description10.1. Serial Communication SettingUse a full crossed (laplink) RS232 cable for serial communication.Also set the following communication parameters:Communication rate: 57,600 bpsNumber of bits: 8Stop bits: 1Parity: noneFlow control: HardwareFile transmission protocol: XMODEM10.2. USB Communication SettingTo establish USB communication, install the enclosed driver,which installs a virtual COM port in the Windows system. Youcan, e.g., use the HyperTerminal communication software forcommunication. Set the following parameters:Transmission rate: 921,600 bpsData bits: 8Parity: noneStop bits: 1Flow control: none10.3. TCP/IP Communication SettingTo communicate with the 2N - VoiceBlue Lite gateway throughthe LAN, set the LAN IP address first. To do this you need a directserial or USB PC connection. You can use such TELNETsupporting programs for TCP/IP communication asHyperTerminal, Putty, etc.91
