Zenith SM3547R Operating Manual & Warranty

Zenith SM3547R Operating Manual & Warranty Manual pdf 25 page image

SETUP MENUTo Access SETUP MenuRefer to the "Using On-ScreenMenus" section for details.Before Using SETUP MenuConnect and turn ON all externalequipment, such as cable TV decoder,VCR, etc. before using any item onthe SETUP Menu.=:;ETUP[AUTO PROGRAMCH. ADD/DELCH. LABELSTUNING BANDAUTO TUNINGSOURCE IDCLOCK SETCAPTIONSMain Setup MenuETUP[SOURCE IDCLOCK SETCAPTIONSSetup Menu for Videoand S-Video SourcesAUTO PROGRAMPurposeFinds all available channels and stores them in the memory ofthe TV for use by CHANNEL (CH) Up/Down.Use AUTO PROGRAM only when you first install your TV,or when you permanently change the connections to the TV.For example, when you replace the antenna with a cable-TVsystem.NOTE: AUTO PROGRAM can only be used with ANT/CABLE 1 or 2 Source selection.To Use AUTO PROGRAM1. Press ADJUST (ADJ) Left/Right to start Auto Pro-gram.2. Use AUTO PROGRAM independently for each AN-TENNA or CABLE signal source connected to yourTV. Select one source by using the SOURCE MENU(ANT/CABLE 1 or 2) and use AUTO PROGRAM.When completed, select the other source and useAUTO PROGRAM again.CH. (Channel) ADD/DEEPurposeLets you add channels to and remove channels from the chan-nel scan. In this way you can customize the channels that areaccessed through CHANNEL (CH) Up/Down.NOTE: CH. ADD/DEL can only be used with ANT/CABLE1 or 2 Source selection.To Add a Channel to Scan Sequence1. Press ADJUST (ADJ) Left/Right to view the channeladd/delete screen.2. Use the number buttons on the remote to enter thechannel or use ADJUST (ADJ) Left/Right and SE-LECT Up/Down to move the highlight to the channelyou wish to add.3. Add the channel by pressing SOURCE until the dis-play shows ADDED._UTOPROGRAMCH.ADD/DELCH.LABELSTUNINGBANDAUTOTUNINGSOURCEIDCLOCKSETCAPTIONS] [ STARTJSelecting Auto ProgramWhen Some Channels Are Not FoundAUTO PROGRAM finds only active channels and storesthem in the favorite channel memory. You can add channels tothose stored in memory by using CH. ADD/DEL.AUTO PROGRAMICH. ADD/DEECH. LABELSTUNING BANDAUTO TUNINGSOURCE IDCLOCK SETCAPTIONS[ [ CH 15ADDSelecting Ch. Add/Del7To Delete a Channel from Scan Sequence1. Press ADJUST (ADJ) Left/Right to view the channeladd/delete screen.2. Use the number buttons on the remote to enter thechannel or use ADJUST (ADJ) Left/Right and SE-LECT Up/Down to move the highlight to the channelyou wish to delete.3. Delete the channel by pressing SOURCE until thedisplay shows DELETED.(continued on next page)2737-0 7_ 1