Zenith SM3547R Operating Manual & Warranty

Zenith SM3547R Operating Manual & Warranty Manual pdf 19 page image

REMOTE CONTROL MODEL MBR3430PROGRAMMING BRAND CODESIntroductionBefore using your new remote control, it must be programmedto recognize the brands of equipment it will be used to oper-ate. If you are using a Zenith VHS VCR or a Zenith cable-TVdecoder, the remote has already been programmed for you.Find the code that corresponds to each brand and type ofequipment you are going to operate. Refer to Tables 1, 2 and 3.For example, if you were programming the remote for usewith a Zenith TV, you would look for "Zenith" in "Table 1",and fmd code "101."Write the brand codes for your equipment on the followinglines.TV CODE:CABLE CODE:VCRCODE:1. Press MODE repeatedly to select the desired TV,VCR or CABLE operating mode for the remote.2. Press LEARN for about 5 seconds until the MODEindicator lights for the selected TV, VCR or CABLEmode of operation.3. Enter the proper brand code number for the equipmentto be controlled.4. Press LEARN. All three mode indicators should lightbriefly, then turn off to indicate the brand code hasbeen programmed.5. If all three mode indicators fail to light briefly, anerror has occurred. Repeat Steps 1-4 to try again.6. Repeat steps 1-4 to program the remote for the otherequipment you are using.NOTE: CABLE mode can be programmed to operate a sec-ond TV or second VCR, if desired.When batteries are removed: It will be necessary to reprogramthe proper VCR and cable-TV decoder codes.Operating ModeIndicatorsNumbered ButtonsUse to enter code numberfor desired brand.LEARN Button(!)(9@@@(9®®@LEARN PiP FREEZEC_SOURCEOFLASHBKCHANNELVOLUMEMUTESWAP TIMER SEORECORD STOP PAUSE SEARCHREW PLAY F FWD TV/VCROperating MODE Selectorz7_6-o 4 _ 6