Z Corporation Z810 System User Manual

Contents

Z Corporation Z810 System User Manual Manual pdf 64 page image

Z Corporation Z810 System User Manualwww.zcorp-users.com 64In this section, you will learn various ways to maximize the versatility of your Z Corporation 3DPrinter through the implementation of advanced part processing techniques. Please visit the UserGroup Website at www.zcorp-users.com for more information. If you have an application you wishto share or have questions regarding any of these applications, please contact the Z CorporationApplications Team at applications@zcorp.com.9.1 GLUING MULTI-PIECED PARTSInstructions:1. Remove and depowder the part as described in section 6 (Removing the Part), and 7(Depowdering the Part).2. Sand seams prior to gluing and check fit of any assemblies. Sanding small parts or partswith curved surfaces can be made easier with a small, air-powered glass airetching/sanding kit.3. Glue seams – use of clamps can assist in the bonding process.4. Sand the seams after they have cured to blend and smooth the edges. You may also fillthe seams with loose powder.5. Priming, filling, and sanding before painting are critical steps in the process. Achievingthe best results sometimes requires application of two coats of primer. A wide variety ofpaints and primers have been successfully used for hi-quality finishes:SEM products (www.semproducts.com )Bondo (www.bondomarhyde.com )Rustoleum Acrylic (www.rustoleum.com)Interlux Brightside Polyurethane6. You may proceed with painting the part. See instructions below for more information onpainting.Follow all safety recommendations regarding handling, storage, venting, and personal protectionequipment when using these kinds of materials. This information can be found on the MaterialSafety Data Sheet of each material.