Z Corporation Z810 System User Manual

Contents

Z Corporation Z810 System User Manual Manual pdf 23 page image

Z810 System User Manual Z CorporationZ Corporation Service (781) 852-5050 / (887) 88-ZCORP 232.2.2 ZD8 CONTROL PANELMainControlSwitchLight PushButtonWarningLampFigure 14: ZD8 Control PanelPLEASE NOTE: If the warning lamp isilluminated (indicating that the filter cleaningcycle has been initiated) and you wouldprefer that the cleaning not occur at thattime, you can pause the cleaning cycle byturning the main control switch to eitherPowder-Drawer-Release mode or Power-Onmode. The cleaning cycle will restart whenthe main control switch is returned to Stand-By mode. This is particularly helpful whenyou want to inspect or unload partsimmediately after depowdering.Main Control Switch:The main control for the ZD8 Depowdering Unit is a 3-position switch. See the table below for a description ofeach position.Position Symbol ModeLeftPowderDrawerReleaseMiddle Stand-byRight Power OnLight Push-Button:The light push button serves two functions:1. Briefly pressing the push-button will toggle the lightsin the workspace On/Off. (This feature is onlyavailable when the ZD8 Depowdering Unit is inStand-by mode.)2. By pressing and holding the push-button until thelamp goes on, the user can initiate the automaticfilter cleaning cycle. (While the filter cleaning cyclecan be initiated at any time, the cleaning will onlystart if the ZD8 Depowdering Unit is in Stand-bymode.)Warning Lamp:The lamp indicates the status of the automatic filter cleaningcycle. See the table below for description of each lampstate.LampState DescriptionOff Filter cleaning is NOTcurrently scheduled.SteadyOnNotice: Filter cleaningcycle has been initiated.Cleaning is scheduled fornext Stand-by mode, andwill start shortly thereafter.FlashingOn/OffCaution: Filter cleaningcurrently in progress.Please stand clear ofmachine.