PrintingXerox ® WorkCentre® 6655/6655i Color Multifunction Printer 93User GuideReleasing the Remaining Prints After Printing a Sample Set1. At the control panel, touch Job Status.2. Touch Held Print Jobs or Active Jobs, then select a folder.3. Touch the corresponding print job in the list.4. Touch Print.The remainder of the job prints, then the printer deletes the job from the printer hard drive.Delay PrintYou can delay a print job for up to 24 hours from the original job submission time. Enter the time atwhich you would like the job to print. If the time you enter is earlier than the time that you submit theprint job, it prints on the following day. The Delayed Print default time is midnight.Sending a Delay Print Job1. On the Printing Options tab, from the Job Type list, select Delay Print.2. In the Delay Print window, select the Tab key to move from the hour section to the minutes section.To select the time to send the print job, click the arrow buttons.− For a 12-hour time format, type the hour (1–12), minutes (00–59), then select A.M. or P.M. Totoggle between A.M. and P.M., click A.M. or P.M., then use the Up arrow or Down arrowbuttons.− For a 24-hour time format, type the hour (1–23) and the minutes (00–59).Note: The regional settings on your computer determine the time format.3. Click OK.4. Select other desired printing options and click OK.5. Click OK or Print.Note: To print the job after you send it but before the scheduled time, release the job at the printercontrol panel.
