Xerox WorkCentre 5755 System Administrator Manual

Also see for WORKCENTRE 5735: Installation guide Information guide User guide System administrator guide Datasheet

Contents

Xerox WorkCentre 5755 System Administrator Manual Manual pdf 91 page image

Network InstallationXerox WorkCentre 5735/5740/5745/5755/5765/5775/5790System Administrator Guide83Installation via DHCP (Dynamic Host Configuration Protocol)DHCP is enabled on the device by default. If the device is connected to the network, the TCP/IPinformation will be configured when the device is powered on and no further configuration is required.Print a Configuration Report to verify that TCP/IP information is correct.1. Press the button on the device.2. Touch the [Machine Information] tab.3. Touch [Print Reports].4. Touch [Print Report].5. Touch [Close].The Configuration Report will print. On the report verify the details under Network Setup heading arecorrect.Installation via BOOTP or DHCPEnsure your device is connected to the network with Ethernet cabling.Note: To configure this feature or these settings access the Tools pathway as a SystemAdministrator. For details, refer to Access Tools Pathway as a System Administrator on page 10.1. From the Tools pathway, touch [Network Settings].2. Touch [TCP IP].3. Touch [TCP/IP Settings].4. Touch [Automatic Addressing]. By default, DHCP is selected.5. Select one of the following required Dynamic Addressing methods:• BOOTP• DHCP• RARP6. Touch [Save].7. Touch [Close].8. Press the button.9. Touch [Logout] to exit the Tools pathway.