Xerox WorkCentre 5755 System Administrator Manual

Also see for WORKCENTRE 5735: Installation guide Information guide User guide System administrator guide Datasheet

Contents

Xerox WorkCentre 5755 System Administrator Manual Manual pdf 20 page image

Device Connection and Quick SetupXerox WorkCentre 5735/5740/5745/5755/5765/5775/5790System Administrator Guide12Settings, to enable the use of the device web user interface for network and options configuration. Ifnecessary, reset TCP/IP Addressing (including DHCP and DNS settings) and enable HTTP as follows:Note: To configure this feature or these settings access the Tools pathway as a SystemAdministrator. For details, refer to Access Tools Pathway as a System Administrator on page 10.1. From the Tools pathway, touch [Network Settings].2. Touch the [Network Setup] button,3. Touch [TCP IP].4. From the TCP/IP screen, touch [HTTP/IPP Enablement].a. For Protocol touch [Enable].b. Touch [Save], to return to the TCP/IP screen.5. Touch [TCP/IP Settings].6. Configure TCP/IP settings, including DHCP (Dynamic Addressing) and DNS, touch [Save], touchthe [Close] button to return to the Network Setting screen.Note: This device supports IPv6 Addressing, with an automatically-built Link Local Address forbroadcasting to routers that can supply the network-layer configuration parameters. SeeConfigure Network Connectivity Protocols with Internet Services on page 17.Quick SetupWhen your device is configured with an IP Address and HTTP is enabled, you can configure networkinformation from your web browser via Internet Services. Enter the IP Address of the device in your webbrowser to access Internet Services. For further information, refer to Internet Services on page 13.