Xerox DocuPrint P8e Service Manual

Also see for DocuPrint P8E: User guide

Contents

Xerox DocuPrint P8e Service Manual Manual pdf 99 page image

7/98Xerox DocuPrint P8e Service Manual 5-27 General Procedures and Information5.7 EPROM Update ProcedureThere are two components in the P8e printer that may be upgraded in the field, a Flash EPROM and anEPROM. The Flash EPROM contains the OS Version and PCL5e Version. The Flash EPROM can beupgraded without any physical work on the printer. The EPROM, on the other hand, must be upgradedby physically changing a chip on a circuit board. The EPROM contains the Engine Version. The two worktogether, you can not mix and match different version numbers.The update procedure works in the following environments:• MS-DOS version 6.22• Windows 95, F8 Command Prompt Only boot• Windows 95, MS-DOS Command Prompt• Windows 95, Shutdown - Restart computer in MS-DOS mode• Windows 3.1, Exit Windows and go to plain DOS version 6.22NOTE: This procedure does not work with the Windows NT Version 4.0 MS-DOS Command Prompt.The procedure requires two zipped files which contain the following files:• fprt.exe• xerox-lt.110 (if default paper size is letter)or xerox-a4.220 (if default paper size is A4)• rom.XXX (XXX represents the version level, i.e. 103 for version 1.03)• boot.XXX (XXX represents the version level, i.e. 103 for version 1.03)The computer’s parallel port should be assigned as standard LPT1 (hex 378) before beginning theprocedure.Procedure1 Unzip the files to a temporary directory.2 Make sure the printer is powered off and the parallel cable is IEEE-1284 compliant andconnected properly.3 Hold the On/Off-line button and switch on the printer. Continue holding the button for 3-4 secondsuntil the LEDs are scrolling in this fashion: error, paper, ready, error, paper, error. Release the On/Off-Line button.4 At the C> prompt, type: fprt boot.XXX lpt1 (XXX represents the version level, i.e. 103 for version1.03).5 When all the LEDs are blinking simultaneously, approximately 10 seconds, switch off the printer.6 Hold the On/Off-line button and switch on the printer. Continue holding the button for 3-4 secondsuntil the LEDs are scrolling in this fashion: error, paper, ready, error, paper, error. Release the On/Off-Line button.7 At the C> prompt, type: fprt rom.XXX lpt1 (XXX represents the version level, i.e. 103 for version