7/98Xerox DocuPrint P8e Service Manual 5-7 General Procedures and Information5.2.3 Clearing Printer MemoryThis function resets the printer, restoring user default settings and clearing all data from the printer’smemory except permanent fonts and macros.To clear printer memory, while the “Ready” LED is OFF (the On/Off-line button has been pressed to takethe printer off line), press and hold the On/Off-line button until all three LED's are blinking. When thebutton is released, all the LEDs except the Ready LED go out.5.2.4 Print Cartridge Cleaning ProcedureThis procedure is used to remove excess toner from the Print Cartridge.To initiate this procedure, the “Ready” LED must be ON.Press and Hold the On/Off-line button until all four LED’s remain lit (not blinking) and the Printer beginsto cycle up (starts the feed of the page).The printer will produce one page. Depending on the contamination, the page may contain a heavyconcentration of background. More than one cleaning cycle may be required to remove contamination.Replace Printer Cartridge if cleaning cycles do not resolve the print quality problem.5.3 Printer SoftwareThe customer has a choice of different software configurations depending upon their needs. TheDocuPrint P8e can be configured for Windows 3.1x, Windows 95/98 or Windows NT 4.0. The printersoftware includes: Print Drivers, Remote Control Panel (RCP), and Status Monitor. This sectiondescribes each of the software selections.These programs enable the user to:• be alerted of any printer changes (Status Monitor)• configure the printer (driver) (RCP for DOS programs inside Windows)• set default parameters for the current print job (driver) (RCP for DOS programs inside Windows)• adjust toner usage (RCP)• print a configuration sheet, handle printer fonts and print a demo page (RCP)
