Xerox DocuPrint 115 System Manual

Also see for DocuPrint 115: System guide Getting started Software guide Planning guide Operation guide

Contents

Xerox DocuPrint 115 System Manual Manual pdf 58 page image

Finishing System Guide6-4 Common Controller• All finishing limitations and restrictions at the printer will applyto a subset segment.PCL Paper Source CommandUse the PCL Paper Source command to programa PCL print job to use a specific paper. The PCL decomposer onthe DocuSP Controller reads the paper source command and,using the PCL Paper Sources option in the Queue Properties,maps the command to the appropriate paper. The number codecorresponds to the following PCL Paper Source Programmed inQueue Properties.To program the PCL Paper Source, use the following guidelines:• Standard: &11H• Manual Paper Feed: &13H• Manual Envelope Feed: &13H• Lower: &14H• Large Capacity: &15H• Envelope Feed: &16HMixed StackingMixed stacking allows all completed jobs with different finishingto accumulate in the stacker until it is full or until the operatorempties it.The types of finishing that can be mixed include stitching,binding, and unfinished. The mixed stack can also includebanner pages. The stacker can hold between 12 and 18subsets of different types of finishing in the stacker beforeunloading.Mixed stacking is enabled upon installation but can be disabled ifyou choose to do so. If you wish to have it enabled at a laterdate, a Xerox Service Representative must assist you.