Xerox DocuPrint 115 System Manual

Also see for DocuPrint 115: System guide Getting started Software guide Planning guide Operation guide

Contents

Xerox DocuPrint 115 System Manual Manual pdf 33 page image

System Guide Security and Network SetupCommon Controller 4-9Remote shell internet serviceIf you are using the print command line client, you will need touse the remote shell internet service to transfer files to theDocuSP server. However, if you are not using the printcommand line client, it is strongly recommended that the remoteshell internet service is disabled.NOTE: If the remote shell internet service is disabled, it isstrongly recommended that it remain disabled. If you are unsurewhether to enable or disable this feature, you should disable it.The disable-security scriptTo disable security, run the disable-security script. Disable-security restores the system to the state it was before configure-xdss was run.The enable-ftp and disable-ftp scriptsFTP services may disable if DocuSP security is enabled. Youmust have FTP enabled to install any client software, or whenusing a Continuous Feed system. To temporarily enable the FTPservices to load client software, run the enable-ftp command.Once client software has been installed, you must run disable-ftpto disable the FTP services again.NOTE: In order to implement the full set of security options,configure-xdss should be run rather than enable-security.NOTE: If enhanced security is enabled on a DocuSPContinuous Feed system, ftp must be enabled by either DigiPathor using the enable-ftp script.The enable-security scriptWhen you run the enable-security script, various security relatedchanged to the Solaris Operating Environment are implemented.All of the changes that are made when this script is run can bereverted by running the disable-security script. The enable-security script implements the following:• Securing Solaris file permissions• Deleting and securing user accounts