Xerox 8200B - Phaser Color Solid Ink Printer Advanced Features And Troubleshooting Manual

Also see for 8200B - Phaser Color Solid Ink Printer: User guide Quick guide Networking Setup Guide Installation Specifications

Contents

Xerox 8200B - Phaser Color Solid Ink Printer Advanced Features And Troubleshooting Manual Manual pdf 63 page image

Advanced Features and Troubleshooting Manual 57TroubleshootingPreventing media jamsUse the following guidelines to prevent media jams inside the printer. Make sure the printer is on a flat, level surface. Don't add media above the tray's fill line. Media: Use only the recommended media. Refer to the Phaser 8200 Color Printer UserGuide or print the Paper Tips Page from the printerís front panel. For transparencies, only use Phaser 860/8200 transparency film, which has beenspecially formulated for use in this printer. Use clean, undamaged paper. Keep paper and other supplies clean and free fromdust. Paper that has been sitting out of its sealed wrapper can become distorted,causing paper jams. Keep paper sealed until you are ready to use it for printing. Do not use paper that has been creased or wrinkled. If paper is still jamming, flip the paper over in the paper tray Do not print on sheets of labels that are missing labels. Use only Phaser 860/8200 printer Color Printing Labels or Xerox PhaserPremium Business Cards. Do not use perforated paper, or odd-sized paper. For three-holed paper, make sure margins are adjusted to avoid printing over theholes. When using the manual-feed slot: Always use two hands to load the media so that it enters evenly. Wait until a front panel message prompts you before feeding the first sheet ofpaper, first transparency, or first envelope. When printing multiple pages, waituntil the front panel message prompts you before adding the next sheet of media. Clean the printerís rollers if they are visibly dirty. Refer to the Phaser 8200 ColorPrinter User Guide for more information about cleaning the rollers. In high-humidity conditions, or when using speciality papers that can be printed onboth sides: Remove the paper from the paper tray, turn over the stack of paper, andreinsert the paper into the tray.After you clear a media jam, the printer sometimes outputs a second, usually partial printto remove any image that may remain on the print drum; then the printer prints youroriginal image.If you have more than one tray, the lower tray is usually the tray that the printer uses inself cleaning. You can change the default tray to use for self cleaning; see Maintenance andCleaning in the Phaser 8200 Color Printer User Guide for more information.