Xerox 8200B - Phaser Color Solid Ink Printer Advanced Features And Troubleshooting Manual

Also see for 8200B - Phaser Color Solid Ink Printer: User guide Quick guide Networking Setup Guide Installation Specifications

Contents

Xerox 8200B - Phaser Color Solid Ink Printer Advanced Features And Troubleshooting Manual Manual pdf 60 page image

Advanced Features and Troubleshooting Manual 54TroubleshootingPrint-quality problemsLight-colored or missing stripes on prints Run a test print by choosing Print Diagnostic Pages on the printerís front panel(by selecting the Support Menu, then selecting Improve Print Quality?). If a light stripe appears in one color, clean the printhead by choosing EliminateLight Stripes on the front panel (by selecting the Support Menu, then selectingImprove Print Quality?). Refer to the Phaser 8200 Color Printer User Guide formore information. If a light stripe appears in all four colors, refer to the Phaser 8200 Color Printer UserGuide for more information about how to: Clean the Rapid Release Guide. Clean the wiper blade on the maintenance drawer. Inspect the printer's paper-exit area for debris and, if needed, clean this area. Select Eliminate Light Stripes on the front panel to clean the print headsand print a test page.Ink streaks or oil on front, back, or edges of print Choose Remove Print Smears on the front panel (by selecting the Support Menu,then selecting Improve Print Quality?). Refer to the Phaser 8200 Color PrinterUser Guide for more information. The cleaning process takes several minutes anduses several blank sheets of paper. Be sure to use paper supported by the printer. For a list of recommended media types,refer to the Phaser 8200 Color Printer User Guide or print the Paper Tips Page (fromthe front panel). If needed, clean the following parts of the printer, as described in the Phaser 8200Color Printer User Guide: Clean the maintenance drawer wiper. Clean the exit rollers if ink or debris is visible on those rollers. Clean the paper-feed rollers if ink or debris is visible on those rollers.Images are too light or too dark Pull out the upper tray and check the position of the switch on the front-right side ofthe tray. Push it forward for paper and backward for transparency. After setting theswitch correctly, push the tray back in. Make sure that you have loaded the correct media (paper or transparencies). For a listof recommended media types, refer to the Phaser 8200 Color Printer User Guide orprint the Paper Tips Page (from the front panel). Select another color correction in the printer driver, then print the job again. Refer topage 3 for more information.