Menu
Xantech MRC88M Installation Instructions Manual
                                                                                                      | |
Contents
| 
Page: 52 Model MRC88m / MRAUDIO8x8m© 2009 Xantech CorporationR EPEAT C OMMANDSCommands can be repeated to extend the amount of time the command is being issued. This is sometimesnecessary for STOP commands or any commands that seem to be intermittent with a short button press.1. To repeat an IR command for any reason, just use the arrows to set the number of times to repeat acode.2. Double Click in the word “REPEAT”. This will place a “cycle” symbol and the words “Repeat 3 Times” (if3 is selected) at the bottom of the Macro Command List.3. Left Click on the “Repeat 3 Times” line and drag it directly ahead of the code to be repeated.PUSH & H OLD (TIERED) C OMMANDSEach programmable button on the virtual keypad can have 2 separate commands associated with it; onethat is issued with a short press of the button and another that is issued when the button is pressed andheld for longer than 1 second.NOTE: Tier 2 commands placed under the POWER button will require the button to be held for 3 Secondsbefore it will execute the Tier 2 command.The commands thus far have been placed, by default, on TIER 1 (or the first level) of the button. If you wishto add a command(s) to the second Tier,1. Click on “TIER 2” in the Command List window. The Tier 1 commands disappear from the MacroCommand List window and the highlighted button is now outlined in red rather than blue.2. Repeat all of the same steps as described for programming Tier 1 Commands.Figure 26Button Edit Pop-Up MenuEDITING BUTTONS (ON THE VIRTUAL KEYPAD)Once a command is placed under a button on the Virtual Keypad and is displayed in the Macro Command Listwindow, the button itself can be edited. These button edit functions can be accessed by right-clicking on thebutton. Doing so will display a pop-up menu of the different edit functions (see Figure 26 above). Each of thefunctions available are described below. |
This manual is suitable for:
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved