Provisioning the cameraProvisioning the cameraTip: Before using the VISTA Body Camera for the first time, fully charge andprovision it.You provision your VISTA Body Camera while it is docked in a USB Base or VISTA TransferStation. When you provision the camera, you use your WatchGuard Evidence Library softwareto assign a configuration and an officer name.Depending on how your agency assigns its cameras, you may need to provision and check outthe camera each time you use it (for example, from a pool of cameras) or only rarely as itsconfiguration needs to be updated (for example, if a camera has been assigned to you long-term).To provision the VISTA Body Camera:1. Dock the camera in the USB Base or Transfer Station connected to your Evidence Librarysoftware.2. Using Evidence Library software, create and/or assign a configuration and an officer to thedocked camera.For instructions how to assign a configuration and officer to the camera, see your EvidenceLibrary software documentation.As a configuration is applied to the camera, the display reads CONFIG. The configurationupdate alert sounds when the update is finished.VISTA Body Camera configurationYou can only create a VISTA Body Camera configuration in your Evidence Library software.Note: For instructions how to create and set up a configuration for the VISTABody Camera, see your Evidence Library software documentation.Some of the configuration properties you can set up for the VISTA Body Camera in yourEvidence Library software include:l Agency or department namel Time zone where the agency or department is locatedl Officer name and badge IDl Device IDl Event tags including a list of possible event categories (page 29)l Officer preferences for indicators, including (page 57)o Alert preference (none, tone, vibration, or tone and vibration together)o LED brightnesso Tone volumeVISTA Body CameraWGD00120 RevisionReviewDraft_11151835
