Using the VISTA Body CameraUndocking the camera from the USB BaseEvidence Library software commands and requests are only applied when the camera isundocked from a USB Base. When you undock the camera, it processes the commands andrequests in the following order, as applicable:1. Performs a state capture.The display reads STATE CAPTURE.2. Updates the configuration.The display reads CONFIG. The configuration update alert sounds when the update isfinished.3. Generates an RATF event.The display reads CREATING RATF.Note: After the RATF event has been generated, the camera starts theevent categorization sequence for the RATF event if it is configured torequire event categorization. For instructions how to categorize anevent, see Categorizing a Recorded Event on page 29.4. Unprotects the recorded events confirmed as imported.This makes the storage space available to be reused as needed.5. Stages the firmware upgrade to perform the next time the camera is docked.Once all the commands and requests are processed, VISTA is ready for normal operation.For more information about the USB Base, see USB Base on page 64.32VISTA Body CameraWGD00120 RevisionReviewDraft_111518
