Wearing the head-mounted camera sensorWearing the head-mounted camera sensorThe glasses mount is available for the head-mounted camera sensor.The glasses mount has been designed to workwith Oakley Flak Jacket® glasses, availablethrough WatchGuard.Using the glasses mountTo use the glasses mount for the head-mounted camerasensor:1. If you have not already done so, disconnect thecable from your VISTA XLT DVR and camera sensor.2. On the Oakley glasses provided by WatchGuard,remove the rubber sleeve from the right arm of theframes.For instructions, see Preparing your Oakley glasses below.3. Snap the glasses mount into the groove on the head-mounted camera sensor.4. Slide the quick mounting latch backwards and open the hinged part of the mount.5. Fit the mount over the raised ovals on the bare arm of the Oakley glasses.6. Close the hinged part of the mount then slide the quick mounting latch forward.Preparing your Oakley glassesNote: Oakley glasses are designed for the arms to be removed and the rubbersleeves to be replaced.To prepare your Oakley glasses for mounting:1. Grasp the right arm of the glasses near the frameand, with gentle force, twist the arm to snap it outof the frame.2. Slide the rubber sleeve off of the arm and set itaside.3. Snap the arm back into the glasses frame.VISTA Body CameraWGD00120 RevisionReviewDraft_11151821
