Unitek DS-405.2 Manual

Contents

Unitek DS-405.2 Manual Manual pdf 49 page image

Control connectionDS 400-2 04/2019 - V01 48X8 as TTL Encoder output5.11 X8 as TTL Encoder outputThe encoder signals supplied by the motor (feedback) are available at the output of the D-connector X8 TTL encoder signals for the CNC control.The encoder output is internally isolated.The voltage is supplied via the encoder line from the CNC/PLC control.Voltage supply +5 V ±0.2 V.The output signal corresponds to RS485.Option: Internal supply from the servo-drive (LBR1 + LBR2)For RS and SC the resolution can be programmed. (Parameter 0 x a4, Bit1),for IN it corresponds to the encoder no. of pulsesDS-400-encoder-outPulse signals(motor revolving clockwise)Output level low < 0,5 Vhigh >4.5 VSlope < 0,1 μsZero pulse min. 0.2 μsOutput frequency max. 200 kHzPulse/rpmfor RS, SC programmablefor IN encoder no. of pulsesX8 as TTL encoder inputNote: X8 pin 6 (select IN) must be bridged with X8 pin 1 (+5V)!The encoder input is internally isolated.The voltage is supplied via the encoder line.Option: Internal supply from the servo-driveThe input signal correspond to RS485.Input frequency max. 200 kHzOption: Internal supply from the servo-drive (LBR1 + LBR2)The encoder input can be programmed for different functions;see software Manual DS-NDrive