Unitek DS-405.2 Manual

Contents

Unitek DS-405.2 Manual Manual pdf 42 page image

Control connection41 04/2019 - V01 DS 400.2CAN-BUS 5.5 CAN-BUSThe CAN-BUS is a digital connection to the CNC control.Optimum conditions are achieved with CNC controls and CAN components of LABOD electronic orCAN Open.Programming and operation by means of the control panel via the CAN-BUS.Interface complies with the standard ISO 11898.Adjustment and programming see Manual DS-CAN.CAN BUS cableUse a shielded bus conductor with a low shielding capacity.Signal plus GND.D-connector with a metal or metallized housing.LiYCY 4x0.25+shield.Designation Connectorno.Cable colourCAN-V+ 9 brownCAN-GND 3 whiteCAN-H 7 greenCAN-L 2 yellowFM=jackCAN BUS connection with several devicesMaster Address xx Address xx Address xxDS-BAx-DPC / E-DS-400-CAN-3x3Terminating resistor at the end of the bus line > 120 Ohm between CAN-H and CAN-L134FM529867134FM529867CAN-V+CAN-H 134FM529867CAN-GNDCAN-L(PE) Schirm am SteckergehäuseX9 X9 X9CAN-BUS DSxx/BAxx DSxx/BAxx DSxx/BAxx120Shield at connector housingThe BUS interface is galvanically isolatedfrom the internal device voltage.The voltage is supplied via an internalisolated DC-DC converter.CAN-V +9 to 15 V=CAN-Bus isoliert /CAN-GND auf gemeinsames Potentialbringen.