Toshiba MMW-AP0481CHQ-E Installation Manual

Also see for MMW-AP0481CHQ-E: Service manual Manual

– 14 – External dimensions (Unit: mm)Anchor bolt hole sizeɸ12 x 17 U hole6005090050594732010958111195201840 403203624002570026981180 100160 65Anchor bolt hole sizeɸ12 x 17 long holeAnchor bolt hole pitchAnchor bolthole pitchIncluding steady legControl wiring /External signal wiring port(ɸ34)Power supply wire port(ɸ34)Water outlet(R1·1/4 male screw)Refrigerant (R410A) pipeconnecting port(Gas side ɸ15.9 flare)Water inlet(R1·1/4 male screw)Refrigerant (R410A) pipeconnecting port(Liquid side ɸ9.5 flare)Drain hole(ɸ25)15464 Fixing the hot water moduleto floorWARNING• Be sure to install the hotwater module in a place ableto bear its weight.If strength is insufficient, the unitmay fall down resulting inhuman injury.• Perform specified installationwork to protect earthquakes.If the hot water module isimperfectly installed, anaccident by falling or droppingmay be caused.CAUTION• Drain water is discharged fromthe hot water module.(Especially while operating)Install the hot water module in aplace with good drainage.• For installation, be careful of thestrength and level of thefoundation so that abnormalsounds (vibration or noise) arenot generated.• Be sure to install the hot water module in a placestrong enough to withstand its weight. If the base isunstable, reinforce with a concrete base.• The hot water module must be anchored on a levelsurface. Use a level to check after installation.• If the hot water module is installed near a roomwhere noise is a problem, using an anti-vibrationstand on the base of the unit is recommended.1. Fix the hot water module with M10 anchor bolts at 4positions. 15 mm projection is appropriate for ananchor bolt.(Unit: mm)1527-EN 28-EN