IPedgeFeature OperationsIPedge UG 01/13 TOSHIBA 53Message Waiting Message Waiting is shown on the Msg button which flashes red when there aremessages waiting. The waiting message indicators can come from the voice mailsystem or they can be internal messages sent from other extensions.The messages from other extensions are notifications that someone has calledyour extension and wants you to call them back.An extension can receive up to three Message Waiting indications, one additionalindicator will always be reserved for the voice mail system.Note: If there are Phantom DNs (PhDNs) programmed on an extension, eachPhDN can receive up to three message waiting indicators.Responding to a LitMsg LED1. Press the Red flashing Msg button. The telephone will dial the messagesource (the voice mail or another extension). See Note below.2. When the call is finished, hang up and the message waiting indicator willclear.3. If the Msg LED continues to flash, there are additional messages to check,repeat steps 1-2.Voice mail devices have a short delay in turning off the message waitingindicators.4. To manually turn off the Msg LED, press your extension button, then enter#409. Repeat this sequence until all the messages are cleared.Notes:• If there is a + on the LCD, press the Next Soft Key to scroll through themessages sent to that extension.• To see who has sent you messages, or to retrieve the messages, press theflashing Msg button.Turning On/Off MWLED on AnotherExtensionWhen an extension is called, the calling party can choose to send a message tothe called party. This is a notification to say that a call has been missed and thecalling party would like to be called back.By sending a message to another extension you turn on their Msg LED.1. Dial an internal extension. You may hear ringing or busy tone.2. Press Msg or 7. The Msg LED flashes red on the called telephone. At yourtelephone, the Msg LED lights steady red and the LCD shows the stationnumber where the Message Waiting light was sent.3. If you decide to cancel the Message Waiting light at this point, press Msg or 7again while ring-over tone is playing and the light will cancel. If you want tocancel the message later, call the telephone where you set the message andpress 7 twice.4. Press Spkr. Your Msg LED turns Off. The Msg LED on the called telephoneflashes until the called party presses the flashing Msg button which calls youback.5. Turn off the Message LED.The two ways to turn Off a Message LED are:Method 1