Toshiba AW-G9930S Service Manual

– 32 –1) Open the lid and remove the control panelaccording to the steps 1) to 4) of (1)Program timer.2) Detach the connector from the reed switch.3) Remove 2 screws of the top cover rear andlift top cover front. (Photo. 26)4) Remove the screw and carefully remove thereed switch with the metal place (coveredwith tape).1) Remove the rear lid.2) Disassemble the pulsator and spin basketaccording to the steps of (10) Pulsator and(11) Wash tub.3) Remove the wires within the cabinet (thelead wire on the top cover side and theconnector of the lead wire on the cabinetside) and the grounding wire (flat washerwith ϕ 4 screw). (Photo. 27)4) Remove the air tube from the air trap.(Photo. 27)5) Remove the (outer) drain hose from thehose outlet, and cut the root of the innerdrain hose from the valve case using acutter knife and remove it.6) Remove the suspensor rod from the cabinetholder and tub holder. (Photo. 28)(Lifting the tub with one hand will make iteasy to float the suspensor rod.)7) Lift the tub up and out.8) Turn the tub upside-down.9) Remove the drain valve motor according tothe steps 2) to 3) of (6) Drain valve motor.* Follow the reverse order of removal.Note 1 : Reed switch lead wires should go alongthe main lead unit.Note 2 : Lid opening detection dimension shouldbe checked 10 - 40 mm as shownFig. 3.(13) Reed switch(14) Tub(Photo. 26)(Photo. 28)(Photo. 27)Parts Procedure ( : Notes) IllustrationsAll manuals and user guides at all-guides.com