Toshiba AW-G9930S Service Manual

– 20 –Check Point(1) Whether foreign matter is caught on the pulsator.(2) Whether the machine is placed on a firm and flat floor.(3) Whether there is an excessively uneven load in the spinbasket.(4) The noise “boon” in supplying water is generated whenthe water intake valve is operated and the noise “za zaa”is generated by the liquid for balance in the spin basket.These are not troubles.(5) You may hear intermittent motor sound (“coon” sound) inspinning process occurs, this is a sound which occurs inorder to control rotation, and not a malfunction.(1) Whether power failure occurs.(2) Whether the house circuit breaker is tripped or a fuse isblown.(3) Whether the power cord is connected to the socketproperly.(4) Whether the power switch turn on, the START/HOLDbutton is pressed.(5) Whether the tap is opened.(1 Warning alarm [E5] is operated.)(6) Whether the proper amount of water is filled.(7) Whether the drain hose is laid down. If the machine isoperated without laying the drain hose down, the operationstops to prevent water flowing around the floor.(1 Warning alarm [E1] is operated.)Whether the softener solidifies in the softener case.Because of the water pressure, the quality of cloth and thedraining condition, the total time may be long.If the automatic unbalance correction is operated, theremaining time is increased.If you put the wet clothes, it may be set the water level higher.Turn off the power switch once and turn on again. Then trythe operation again.If the machine would not operate, unplug the power cordonce and plug it in to start operation again.When water is supplied some amount, the pulsator rotates.Then washing and rinsing start.By spinning control, for some time (approx. 2 - 3 min.) afterspinning started, the rotation speed is low.For spinning the rotation speed varies and you may hearmotor sound (“coon” sound). It cause the rotation speed iscontrolled.Diagnosis8Abnormal noiseoccurs9The washingmachine does notoperate.!Softener is noteffective."The remaining timedoes not suit to thetotal time.#Water levelcontrolled by thewashing amountsensor does notreach to theexpected level.$The operation isnot performed tobe expected.%The pulsator rotatesduring watersupplying in thewash or rinse cycle.&The spinningspeed varies.RemedyAfter repairing, press theSTART/HOLD buttonagain.After repairing, press theSTART/HOLD buttonagain.Remove the softener caseand wash it.This is not trouble.Adjust the washingamount sensor.(Refer to the Owner’sManual)Refer to the Owner’sManualThis is not trouble.This is not trouble.All manuals and user guides at all-guides.comall-guides.com