Toshiba AW-G9930S Service Manual

– 24 –Parts Procedure ( : Notes) Illustrations(2) Water intakevalve,Water feedcase assy1) Remove the detergent case.2) Remove 2 back cover mounting screws atrear. (Photo. 5)3) Remove the back cover by inserting ascrewdriver (-) from the lower end of thebottom.4) Disconnect 4 connectors of the intake valve.5) Intake valve and water feed case arestructured together. Remove it by releasing2 catches at rear side of the water feed caseand then by lifting it. (Photo. 6 )6) Take out the intake valve and the valvemounting base from the water feed case(3 screws). When reassembling, do notforget to mount the packing and the spacer(each 2 pieces). (Fig. 1)1) Remove the rear lid (6 screws).2) Remove 2 lead wire clamps from thecabinet,and remove wire harness from the cordclamper (1 Screw). (Photo. 7)3) Remove 4 top and back cover mountingscrews (each 2 screws).4) Remove the top cover by lifting at rear sideslightly and sliding forward.Note 1 : When replacing the intake valve, alwaysuse new packing and spacer suppliedwith the intake valve.Note 2 : After mounting the water feed case, tryto make a test operation and make sureno water leakage exists before mountingthe back cover.CAUTIONWATER LEAKAGEx Before stating washing, open the faucet and check that the water supply hose joint isnot loose and no water leaks.The loose screw or hose joint may cause water leakage resulting in an unexpecteddamage.(3) Lid switch(Photo. 5)(Photo. 6)Water feed caseHolderWaterintake valveScrews (x3)(Fig. 1)(Photo. 7)All manuals and user guides at all-guides.com