Toshiba AJ65VBTCU-68ADVN User Manual

Contents

4 - 7 4 - 7MELSEC-A4 SETUP AND PREPARATION BEFORE OPERATION(2) Applicable combinations and setting conceptsThe following table indicates usability according to the combinations of themaster modules, the mode setting and station information (station type) of theGX Developer network parameters, and the mode select switch setting of themodule. Refer to the following table and make selection.: Usable, : UnusableNetwork Parameter Setting Model Select Switch Setting ofAJ65VBTCU-68ADVN/ADINMaster ModuleMode setting Station information(station type)Ver. 1 remote devicestation (Ver. 1 compatibleslave station)Ver. 2 remote devicestation (Ver. 2 compatibleslave station)Remote net ver.1 modeRemote devicestation Concept AVer. 1 remotedevice stationRemote net ver.2 mode Ver. 2 remotedevice stationVer. 1 remotedevice stationQJ61BT11AJ61BT11A1SJ61BT11AJ61QBT11A1SJ61QBT11 Remote netadditional mode Ver. 2 remotedevice stationRemote net ver.1 modeRemote devicestation Concept BVer. 1 remotedevice station Concept CRemote net ver.2 mode Ver. 2 remotedevice station Concept DVer. 1 remotedevice station Concept EQJ61BT11NRemote netadditional mode Ver. 2 remotedevice station Concept FSetting Concept OutlineConcept A Select this concept when system expansion is not necessary. Select this concept whenthe module replaces the conventional one as a maintenance product.Concept B Select this concept when system expansion is not necessary. Select this concept whenthe module replaces the conventional one as a maintenance product.Concept C Select this concept when configuring a new system. The ver. 1 compatible slave stationand ver. 2 compatible slave station can be mixed. The ver. 1 remote device stationoccupies 3 stations.Concept D Select this concept when configuring a new system. The ver. 1 compatible slave stationand ver. 2 compatible slave station can be mixed. The ver. 2 remote device stationoccupies 1 station, and can connect more devices. Refer to Chapter 5 Programming.Concept E This concept allows this module to be newly added to the existing system. When there isa station number used as the ver. 2 remote device station in the existing system, set thestation number of the ver. 1 remote device station to be added before that station.The ver. 1 remote device station occupies 3 stations.Concept F This concept allows this module to be newly added to the existing system.Set the station number of the ver. 2 remote device station to be added after the stationnumbers used in the existing system. The ver. 2 remote device station occupies 1 station,and can connect more devices. Refer to Chapter 5 Programming.POINTFor use in the remote net ver. 2 mode or remote net additional mode, the mastermodule of QJ61BT11N and the peripheral software package of GX DeveloperVersion 8.03D or later are required.For more information on the applicable modules (CPU modules, network modules)and applicable software packages, refer to the CC-Link System Master/LocalModule User's Manual (Details) QJ61BT11N.