OPERATING BASICS4-9LANAuto SwitchWhen Auto Switch is selected, this application automatically enables the wirelessLAN device when you disconnect the LAN cable. This feature works only if a wiredLAN device is currently enabled and the LAN uses TCP/IP protocol.DisabledClick Disabled to disable or enable this program’s features.HelpClick Help to display a readme file.ExitClick Exit to quit the program.NOTES: 1. If you change the network device, you might need to logonto the network again.2. Log on as the administrator.If the Control device power management checkbox in the Device Settings windowof Power Saver is enabled, the following four events will trigger a change in settingsmade in the Device Setting window of the Power Saver utility. The change will occurregardless of the Network Device Switch setting. To avoid these automaticchanges, clear the Control device power management checkbox in the PowerSaver utility. For details, refer to the Power Saver utility’s help files.1. You start the computer on battery power.2. You start the computer with the AC adapter connected and disconnect the ACadapter during operation.3. You change the Power Saver settings.4. The computer resumes operation in suspend or hibernation mode.
