Toshiba 19SL410U Owner's Manual

Also see for 19SL410U: Owner's manual Specifications Energy guide

Contents

24Initial SetupWhen you first turn on or reset the TV, the InitialSetup window will appear.1 In the Menu Language field, press W or X toselect your preferred language.2 Press S or T to select Time Zone Setup and setyour desired time zone with W or X and press.3 Next, the Location setting window will appear.For normal home use, press to select Home.4 Next, ANT/CABLE In setup window will appear.Press W or X to select the input source (Cable orAntenna) for the ANT/CABLE input on the TV.5 If you select Antenna, the Channel Tuning Modesetup window will appear. To tune only digitalchannels, select Digital. To tune digital channelspreferentially over analog when entering channelnumber directly, select Auto. For normal tuning,select Standard. Press to continue to AutoTuning.6 Press to select Start Scan and continue withthe Auto Tuning.You can stop the Initial Setup with . However ifyou do not finish the entire Initial Setup process, theInitial Setup window will appear every time you turnon the TV.Selecting the menu languageYou can choose from three different languages(English, French, and Spanish) for the on-screendisplay of menus and messages.To select the menu language:1 Press and open the Preferences menu,highlight Menu Language.2 Press W or X to select your preferred menulanguage.3 Press to close the Preferences menu.Configuring the antenna inputsource for the ANT/CABLE terminalTo configure the ANT/CABLE input source:1 Press and open the Setup menu.2 Highlight Installation and press .3 (A new set of Installation menu icons will appear,as shown below.) Open the Terrestrial menu,highlight Input Configuration, and press .4 Highlight ANT/CABLE In and press W or X toselect the input source (Cable or Antenna) for theANT/CABLE input on the TV.5 To save your new settings, highlight Done andpress . To revert to your original settings,highlight Cancel and press .Programming channels into theTV’s channel memoryWhen you press or on the remote control orTV control panel, your TV will stop only on thechannels you programmed into the TV’s channelmemory.Follow the steps below to program channels into theTV’s channel memory.Chapter 5: Setting up your TVPreferencesCC SelectorBase CC Mode OffDigital CC SettingsInput LabelingChannel Labeling AutoMenu LanguageChannel Browser SetupREGZA-LINK Player ControlEnglishSetupInstallationREGZA-LINK SetupSleep TimerPC SettingsMedia PlayerTerrestrialInput ConfigurationChannel ProgramChannel OptionsChannel Tuning Mode AutoTime ZoneSignal MeterInstallationInput ConfigurationANT/CABLE In AntennaCancel Done