Toshiba 120/150 Operator's Manual

Contents

7-19Windows 98/Me/2000To scan directly into an application using the Button Manager on Windows 98, Windows Me and Windows2000. Set the Event Manager properties to send only to Button Manager as shown below.1 Click the “Start” button, select “Control Panel” from “Settings”, and open “Scanners and Cameras”in start menu.In Windows Me, it occasionally happens that the “Scanners and Cameras” icon does notappear immediately after installation of the MFP driver is completed. If the icon does notappear, click “View all Control Panel options” in the Control Panel and display the “Scannerand Cameras” icon.2 Select “e-STUDIOxxx” (where “xxx” is the model name of your unit), and click the “Properties”button.In Windows Me, right click “e-STUDIOxxx” (where “xxx” is model name of your unit) and click “Properties”in the menu that appears.3 In the “Properties” screen, click the “Events” tab.4 Click the “Scanner events” button and select “ScanMenu SC1”from the pull-down menu. Select “Button Manager (TOSHIBAPersonal MFP series)” in “Send to this application” and click“Apply”.If other application are shown, deselect the checkboxes forthe other applications and leave only the Button Managercheckbox selected.5 Repeat Step4 to set “ScanMenu SC2” through “ScanMenu SC6”.Click the “Scanner events” and select “ScanMenu SC2” from the pull-down menu. Select “ButtonManager (TOSHIBA Personal MFP series)” in “Start this program” and click “Apply”. Do the same foreach ScanMenu through “ScanMenu SC6”.When the settings have been completed, click the “OK” button to close the screen. When the settingshave been completed in Windows, start the Button Manager. Adjust detailed settings and then scanan image from the unit. For the procedures for starting Button Manager and adjusting settings, see“Scan Parameter Setting Dialog Box” (Next page).