6-6 TROUBLESHOOTING2 Gently remove the misfed paper from under the fusing unit as shown in the illustration. If thepaper cannot be removed, proceed to “C: Misfeed in the transport area”.The fusing unit is hot. Do not touch the fusing unit when removing misfed paper. Doing somay cause a burn or other injury.•Do not touch the photoconductive drum (green portion) when removing the misfed paper.Doing so may cause smudges on copies.•Do not remove the misfed paper from above the fusing unit. Unfixed toner on the papermay stain the paper transport area, resulting in smudges on copies.3 Raise the fusing unit release lever and then close the side cover by pressing the roundprojections near the side cover open button. The misfeed ( ) indicator will go out and thestart ( ) indicator will light up.C: Misfeed in the transport area1 Lower the fusing unit release lever.See B: Misfeed in the fusing area (p. 6-5).2 Open the front cover.To open the front cover, see “TONER CARTRIDGE REPLACEMENT” (p. 5-2).3 Rotate the feeding roller in the direction of the arrow and gently remove the misfed paper fromthe exit area.Feeding roller
