Toshiba 120/150 Operator's Manual

Contents

7-137 Copying files for MFP driver installation and parallel interface setup (This step will start if itwas selected in step 4).1. After confirming the message in the “Welcome” window, click the “Next” button.2. A dialog box appears asking you to verify that the USB or parallel interface cable is not connectedto the MFP. Make sure that the interface cable is not connected and click the “Next” button.3. Click the “Next” button in the dialog box to install the MFPdriver or Cancel to quit the installation.• The setup program will start to copy the files.• In Windows 2000, if the following screen appears whilethe files are being copied (the message may appear morethan once), click “Yes” in Windows 2000.4. The following screen appears. Click the “Yes” button, and then the Model screen will appear. Selectthe model number that is the same as the model name of your MFP and click the “Next” button.• Be sure to select the displayed model number that is the same as the MFP’s model name. If theyare not the same, the driver will not be installed correctly.5. Establish the printer settings and click the “Next” button.• Select “LPT1” for the port to be used. If “LPT1” does notappear, it is likely that another printer or peripheral deviceis using “LPT1”. Check your other printers and peripheraldevices, and change the port setting as needed so nodevice is using “LPT1”. If you wish the MFP to be yourdefault printer, select “Yes”. If not, select “No”.6. When the “Setup has completed gathering all necessary installation information” dialog boxappears, click the “Yes” button.• The parallel interface driver is installed.7. When the “The MFP driver installation is complete.” dialog box appears, click the “OK” button.• The Desktop Document Manager installer will start.