Toro Z Master 8000 Series Operator's Manual

Also see for 74311TE: Operator's manual Setup instructions Operator's manual

Adjusting the Fill ReductionSystem (FRS) BafflesThe fill reduction system has been designed to allowyou to reduce the amount of clippings collectedby varying degrees. The advantages include lessfrequent emptying of the hopper and the return ofnutrients to the soil.The following are possible configurations:• Baffles open with standard blades—maximumcollection• Baffles closed with standard blades—partialmulching• Baffles closed with mulch blades—intermediatemulching• Mulch plug installed with mulch blades—completemulching (requires mulch kit)Adjust the FRS baffles as follows:1. Park the machine on a level surface, disengagethe PTO, and engage the parking brake.2. Shut off the engine, remove the key, and waitfor all moving parts to stop before leaving theoperating position.3. Loosen the bolts attached to the rubber guard(Figure 10).4. Fold the guard forward.g036545Figure 101. Bolts 2. Rubber guard5. Loosen the locknuts on the rear studs of theFRS baffles.g025242Figure 111. PTO guard removed forclarity2. Loosen the locknuts.6. Raise the mower deck; refer to Raising theMower Deck into the Service Position (page 16).7. Remove the bolt and washer at the front of eachFRS baffle (Figure 12).8. Rotate the baffles into the desired position andinstall the bolt and washer.g007577Figure 121. Baffles—closed position2. Baffles—open position3. Bolt4. Washer5. Baffles9. Lower the mower deck; refer to Lowering theMower Deck to the Operating Position (page 16).17