Menu
Toro RT600 Operator's Manual
                            | |
Figure 461. Lifting strap 3. Idler wheel2. Digging chain6. Shut off the machine and remove the key.7. Remove the lifting strap from the machine.Linking the Digging Chain1. At the end of the chain laying on the ground, loop thelifting strap around the chain at the digging tooth ofthe fifth or sixth link of the chain (Figure 46).2. Raise the chain and position it around the idler wheel(Figure 46 and Figure 41).Note: Rotate the auger as necessary to engage theteeth of auger drive sprocket with the digging chain.3. Clamp the ends of the chain with a with a chain clampat the link rollers at either side of the inner and outerplates at the master pin (Figure 41).4. Align the hole of a link roller with the holes in the innerplates at the end of the chain (Figure 42).5. Align the holes in the inner plates and the roller of thechain with the holes in the outer plates of the other endof the chain (Figure 42).6. Align the master pin with the hole in the pin parallelwith the chain plates forward of the idler wheel (Figure42).7. Insert the master pin through the digging chain plates.8. Insert the safety pin through the master pin with thehead of the pin toward the idler wheel (Figure 42).Important: Do not install a used safety pin. Onlyuse a new safety pin.9. Remove the lifting strap and the chain clamp.10. Bend the tail of the safety pin down 30° to 45° (Figure42).11. Adjust the tension of the digging chain; refer toChecking the Chain Tension (page 18).Storage1. Before storing the machine, brush off the dirt fromthe attachment.2. Check the condition of the digging chain. Adjust andlubricate the chain. Replace any worn or damagedparts.3. Check and tighten all bolts, nuts, and screws. Repair orreplace any part that is damaged or worn.4. Ensure that all hydraulic couplers are connectedtogether to prevent contaminating the hydraulic system.5. Paint all scratched or bare metal surfaces with paintavailable from an Authorized Service Dealer.6. Store the attachment in a clean, dry garage or storagearea. Cover the trencher to protect it and keep it clean.25 |
Product
Learn More
Legal
Copyright © 2024 OneStart. All Rights Reserved