Toro Greensmaster 3200 Service Manual

Also see for 3200: Operator's manual Operator's manual Operator's manual Operator's manual Installation instructions

Greensmaster 3200/3200–D Page 7 – 7 Wheels and BrakesRear Wheel (3WD)1. Castor fork2. Hydraulic motor & hub assembly3. Hydraulic hose4. Hydraulic hose5. Bearing6. Relube flangette7. Standard flangette8. Bearing tab9. Hex head screw10. Lock nut11. Socket head screw12. Lock nut13. Cable tie14. Tube clamp15. Cover plate16. Hex head screw17. Lock nut18. Clamp bracket19. Wide head taper screw20. 3WD decal21. Grease fitting22. Set screw23. Lug nut24. Wheel25. Grease fittingFigure 4101713129814 319161815147526112220212324FRONTRIGHT25Removal (Fig. 4)1. Park machine on a level surface. Make sure engineis off. Set brake and block front wheels.2. Jack up and secure the rear wheel off the ground.CAUTIONSupport wheel (24) and motor and hub as-sembly (12) to prevent dropping them andcausing personal injury while removing hexhead screws (9) and socket head screws(11).3. Remove wheel (24) and hydraulic motor and hubassembly (2) from the castor fork (1) as follows:A. Remove hex head screws (9) and lock nuts (10)securing flangettes (6 and 7) and bearing tab (8).B. Remove both socket head screws (11) and locknuts (12) securing the hydraulic motor and hub as-sembly to the castor fork (1).C. Lower wheel and hydraulic motor and hub as-sembly from the castor fork.4. Loosen set screws (22) on bearing (5). Pull flan-gettes (6 and 7) and bearing from the hydraulic motorshaft.5. Remove grease fitting (25) from the hydraulic motorand hub assembly (2). Remove four lug nuts (23) andwheel (24) from the hub drive studs.6. If the castor fork (1) requires removal, see RearWheel (2WD) Removal.Wheels & Brakes